I can take a look and draw some plans, perhaps even a PCB plan.
But I have to wait to I am back at school in 2 about weeks
Alexander Frøyseth
Andy Green skrev:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Somebody in the thread at some point said:
| 3. Carefully slice open the cable and solder in the appropriate
resistor
| between the appropriate conductors (someone needs to document this)
Annoyingly enough this will be the hard bit because the fifth ID pin is
typically not connected to any wire in the cable.
- -Andy
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.8 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org
iEYEARECAAYFAkfycCIACgkQOjLpvpq7dMqMVwCffe/DRp+ZTj+ZseQevodT1cjN
y2IAn0RL2NTs14oz3/dv80Jv7Pbw+LAS
=RaeL
-----END PGP SIGNATURE-----
_______________________________________________
Openmoko community mailing list
community@lists.openmoko.org
http://lists.openmoko.org/mailman/listinfo/community
_______________________________________________
Openmoko community mailing list
community@lists.openmoko.org
http://lists.openmoko.org/mailman/listinfo/community
