Hi, I cant get openocd working (with Debug Board v3 and GTA02), I just get this error message:
$ openocd -f /etc/openocd/openocd.conf Info: openocd.c:84 main(): Open On-Chip Debugger (2007-01-31 12:00 CET) Error: ft2232.c:1351 ft2232_init(): unable to open ftdi device: ftdi_usb_reset failed Can anyone please help me? messages from dmesg: [ 275.629104] usb 1-1.1: new full speed USB device using uhci_hcd and address 9 [ 275.684969] usb 1-1.1: configuration #1 chosen from 1 choice [ 275.692679] ftdi_sio 1-1.1:1.0: FTDI USB Serial Device converter detected [ 275.692726] /build/buildd/linux-2.6.24/drivers/usb/serial/ftdi_sio.c: Detected FT2232C [ 275.692879] usb 1-1.1: FTDI USB Serial Device converter now attached to ttyUSB0 [ 275.700444] ftdi_sio 1-1.1:1.1: FTDI USB Serial Device converter detected [ 275.700488] /build/buildd/linux-2.6.24/drivers/usb/serial/ftdi_sio.c: Detected FT2232C [ 275.700613] usb 1-1.1: FTDI USB Serial Device converter now attached to ttyUSB1 [ 328.625095] ftdi_sio ttyUSB0: FTDI USB Serial Device converter now disconnected from ttyUSB0 [ 328.625562] ftdi_sio 1-1.1:1.0: device disconnected [ 328.626567] usb 1-1.1: usbfs: interface 1 claimed by ftdi_sio while 'openocd' sets config #1 [ 328.627572] usb 1-1.1: usbfs: USBDEVFS_CONTROL failed cmd openocd rqt 64 rq 0 len 0 ret -71 -Morten Freberg
_______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
