Hypnotize wrote: > I have tried that to and get the same error messages! :(
Hi! I go the debug board working the first time just a minute ago, but I had the same errors. Make sure, you have the flat flexible cable between debug board and freerunner completely plugged into the small connector on the freerunner. This solved my problems ;-) andi > > On Sun, Sep 7, 2008 at 3:52 AM, Holger Freyther <[EMAIL PROTECTED] > <mailto:[EMAIL PROTECTED]>> wrote: > > On Sunday 07 September 2008 02:22:40 Hypnotize wrote: > > Hi, > > > > I cant get openocd working (with Debug Board v3 and GTA02), I > just get this > > error message: > > > > $ openocd -f /etc/openocd/openocd.conf > > Info: openocd.c:84 main(): Open On-Chip Debugger (2007-01-31 > 12:00 CET) > > Error: ft2232.c:1351 ft2232_init(): unable to open ftdi device: > > ftdi_usb_reset failed > > sudo openocd? > > z. > > _______________________________________________ > Openmoko community mailing list > [email protected] <mailto:[email protected]> > http://lists.openmoko.org/mailman/listinfo/community > > > ------------------------------------------------------------------------ > > _______________________________________________ > Openmoko community mailing list > [email protected] > http://lists.openmoko.org/mailman/listinfo/community > _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
