Ok, I prepared the SD card with the boot loader and the kernel, and set the SMDK6410 cfg switches/jumpers to boot it from SD. But nothing shows up on the LCD. Can anyone (possibly Andy) tell me what should I expect when the kernel boots? and how can I see the ash prompt in the Busybox (as declared by andy)?
- Tarandeep On Thu, Jan 8, 2009 at 11:10 AM, Tarandeep Gill <[email protected]> wrote: > What I guess is, dfu-util does not write to s3c6410 right now, thats > why Andy has a small utility that transfers the bootloader and the > kernel to a SD card. And I guess right now SMDK6410 (the demo board) > can only be booted with the SD card. Am I correct here? > > - Tarandeep > > On Thu, Jan 8, 2009 at 6:56 AM, Sander van Grieken <[email protected]> wrote: >>>> No DFU capable USB device found >>>> ---------------------------------------------------------------------------------------------------------------------------------------- >>>> >>>> Can you please tell me how to transfer the boot loader and the kernel >>>> to the NAND? >>> >>> not the slightest clue, what you are talking about :-), but i think you >>> can give the device id (see lsusb), too, to dfu-util. >> >> dfu-util should autodetect all DFU capable devices, so if it doesn't find >> one it is >> probably not DFU capable. >> >> I noticed this because my usb sound card was brutely reset when I tried to >> flash the FR ;) >> >> grtz, >> Sander >> >> >> >> _______________________________________________ >> Openmoko community mailing list >> [email protected] >> http://lists.openmoko.org/mailman/listinfo/community >> > _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
