Le Wed, 28 Jan 2009 13:02:47 +0000, Andy Green <a...@openmoko.com> a écrit :
> -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > Only certain magical versions of libftdi will work. 0.8 works fine > here, nothing later did. > So, I updated my software to libftdi 0.8 and openocd r130, without success. I could borrow a multimeter today. The fpc cable is good, the connector on the debug board seems good. Testing the neo side gives stranges results. The first test I made, was to verify contacts between the 45pins on the cable and the h-tp150[23458] dots on the neo pcb. It worked once. Then I unplugged the cable, made various tests with both side (un)plugged. There is continuity between the connectors (wire on the white plastic), but the h-tp150* dots didn't beep again. I didn't succeed anymore with the first test. Then, I try to use openocd, and notice that the neo screen flashes less often. So the connector on the neo pcb seem's dead :( I didn't have tools to make electronics and soldier wires to h-tp150* dots, so I wonder if someone had already got success with scotch and small copper wire ? wiring these dots to the 20 pins empty connector of the debug board ? -- Frederic Leroy P.S : What is the led7 on the debug board ? It blinks randomly when the cable moves. And googling around, I didn't found if it is good that the neo screen flashes and stay sometimes on until I launch openocd. _______________________________________________ Openmoko community mailing list community@lists.openmoko.org http://lists.openmoko.org/mailman/listinfo/community