Sven Hartrumpf píše v So 09. 04. 2011 v 12:11 +0200: > Hi. > > Fri, 08 Apr 2011 21:26:31 +0200, pini wrote: > >> I am trying Navit for the first time and followed these instructions: > >> > >> http://wiki.openmoko.org/wiki/QtMoko#Navit_Installation > >> > >> Works fine, but after the suggested reboot, I just see > >> "Enter PIN the press Unlock" (no numbers field as usual). > >> The screen and the buttons do not react in any way. > > I had to flash again :-( > > > IIUC qtmoko is based on Debian. Why not install > > Because I trusted the Wiki page :-) > Could someone knowledgable update the Navit section, please? > (OK, _if_ I get Navit working (see below), I could do this myself.) > > > Navit from the > > appropriate Debian repository? > > OK. I tried this now. > > The following works without adjusting repositories: > > apt-get install navit
I did the same. Also gpsd should be installed. Then I installed Xglamo and Navit seems to run, but it is bigger than the screen (I can!t see part of the Navit keyboard, etc.) and I don!t have any Navit icon in QX. > > When I started QX from the GUI I had to install an X server. > Which one is recommended? (Xorg or Xglamo?) > I tried both, but with no success (I saw Raptor install packages, > but no error message; it could be that the root fs is full now). > > So, I tried > > apt-get install xserver-xorg > > which worked, but starting xterm (or navit) from QX leads to: > > "Unable to connect to X server" > > Ciao > Sven > > _______________________________________________ > Openmoko community mailing list > [email protected] > http://lists.openmoko.org/mailman/listinfo/community > _______________________________________________ Openmoko community mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/community
