Why not add information about free fw and loader to the mentioned wiki page?
So that people who are not in this mailing list, may know about this fw
and a free fc-load tool.

Also, it would be good to have step by step instructions like get this
source here, compile it like that, get another source there, compile it,
and run this command with these arguments.

10/22/13 10:21 -ում, Michael Spacefalcon-ը գրել է:
> Jose Luis Perez Diez <jl...@escomposlinux.org> wrote:
>
>> The procces to flash GSM firmware used linux, the serial port,
>> and the fluid binary see 
>>
>> http://wiki.openmoko.org/wiki/GSM/Flashing#Manual_Update_.28GTA01.2C_GTA02.29_.2F_geek_way
> Yes, and that exact same procedure should work just as well if you
> substitute your own *.m0 image built from my leo2moko-r1.tar.xz source
> in the place of calypso-moko11.m0.  I say "should" because I haven't
> tried it myself - like Richard Stallman, I avoid proprietary software,
> so I use my own fc-loadtool instead of that fluid.exe for which I have
> no corresponding source.
>
> Just give it a try - if you don't like my illegally-free GSM fw, you
> can always reflash back to the official calypso-moko11.m0.
> Patryk Benderz <patryk.bend...@esp.pl> wrote:
>
>> Can't we just use dfu-util?
> The GSM modem has its own processor, its own independent address space,
> its own address and data buses, and its own independent flash memory
> (NOR in a Multi-Chip Package combined with SRAM).  Neither dfu-util
> nor the AP (application processor) bootloader it is talking to knows
> anything about that separate hardware block.
>
> In order to reflash the GSM modem, one needs to establish communication
> with Calypso's own boot ROM.  That can be done either from a running
> Linux system on the phone's AP (i.e., from inside the phone) or
> externally via a classic "T191 unlock" cable plugged into the headset
> jack.  (The latter approach makes more sense for FreeCalypso
> developers.)  Either way, one needs Linux software running on the
> phone's AP in order to control the power to the modem and to enable
> the headset jack serial channel if you wish to use the latter.
>
> VLR,
> SF
>
> _______________________________________________
> Openmoko community mailing list
> community@lists.openmoko.org
> http://lists.openmoko.org/mailman/listinfo/community


_______________________________________________
Openmoko community mailing list
community@lists.openmoko.org
http://lists.openmoko.org/mailman/listinfo/community

Reply via email to