Re: SE/30 screen wobble

[John F. Scipione]

You can try adjusting the ports on the outside of the analog board to 
see if any of the adjustments will get you a better picture.  You are 
suppose to use some special tool to turn the knobs but I just use a 
small flathead screwdriver.  Can you describe a little better how 
exactly the screen is distorted, maybe then I could give better advice. 
 Is the screen shaking?  Is it bent inward on the top?  is it distorted 
on all 4 sides?  Is the picture fuzzy or sharp?  Do you get a startup 
bong?

Skipp

On Jan 31, 2004, at 9:10 PM, Graham Cox wrote:

I have an SE/30 that works fine, but the screen image is a little 
bent, particularly along the top edge, where it dips down about 2/3 of 
the way across. I can access the usual image size pots, but not sure 
is this will help with this. Any ideas? Does the tube need degaussing? 
Any idea how to do this?

TIA, Graham


--
Compact Macs is sponsored by <http://lowendmac.com/>.
     Support Low End Mac <http://lowendmac.com/lists/support.html>

Compact Macs list info: <http://lowendmac.com/lists/compact.shtml>
 --> AOL users, remove "mailto:";
Send list messages to:  <mailto:[EMAIL PROTECTED]>
To unsubscribe, email:  <mailto:[EMAIL PROTECTED]>
For digest mode, email: <mailto:[EMAIL PROTECTED]>
Subscription questions: <mailto:[EMAIL PROTECTED]>
Archive:<http://www.mail-archive.com/compact.macs%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com
---------------------------------------------------------------