http://qa.mandrakesoft.com/show_bug.cgi?id=781
------- Additional Comments From [EMAIL PROTECTED] 2003-03-15 15:44 ------- Yup network works almost fine now. It loads just fine so this bug is fixed but it still doesn't work in 100mbit mode. Is there an option where I could force it to work in 100mbit or to force autonegotiation with router? In Windows XP on the same machine I have set to autonegotiate line speed and it works on 100mbit just fine. ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is. ------- Reminder: ------- assigned_to: [EMAIL PROTECTED] status: RESOLVED creation_date: description: I installed Manrake 9.1 beta 1 and during installation I selected to configure network. It detected my card (3Com 3C905B) and I selected to use DHCP to configure IP address. But after I restarted the computer I got an error that eth0 was unable to start. It suggested to check cable. I have Windows XP pro on the same machine and it is also set to use DHCP and to automatically negotitate mode and speed. My network card is connected to LevelOne FBR-1403TX router and in Windows XP Pro the NIC is correctly set to full duplex mode and 100 mbit speed. All works fine in Windows. So I think there is nothing wrong with cabling or something. It looks like Mandrake Connection wizzard doesn't set the network card up correctly. I also tried to configure the network after the installation from Mandrake Control Center and eth0 still can't start up. I searched all around to find the place where I could manualy set duplex mode and line speed or enable auto negotiation but I was unable to find this.