Did it not print or did only the calibration not work?
Or didn't you find this printer in the printer listing?
The calibration is still alpha, perhaps I will take it out again.
Till
Peter Ruskin wrote:
>
> HP720C
> Still not working with cups 1.1.2-22mdk and cups-drivers 0.3.6-12mdk...
>
> ESP Printer Calibration Tool v1.0
> Copyright 1999-2000 by Easy Software Products, All Rights Reserved.
>
> Printer name [default]?
> Resolution [default]? 600x600
> Media type [default]?
> Press ENTER to print pass #1 or N to skip...
> Sending calibration pass #1 for density/saturation levels...
> Calibration pass #1 sent.
>
> Please select the character that corresponds to the black block that
> is 100aturated (dark) while not bleeding through the paper. If
> the saturation point appears to occur between two characters, enter
> both characters.
>
> Black density? f
>
> Now select the character that corresponds to the yellow block that is
> 100aturated (dark) while not bleeding through the paper. If the
> saturation point appears to occur between two characters, enter both
> characters.
>
> Yellow density?
> Yellow density? f
>
> Now select the character that corresponds to the red block that is
> 100aturated (dark) while not bleeding through the paper. If the
> saturation point appears to occur between two characters, enter both
> characters.
>
> Red density? f
>
> Thank you. Now insert the page back into the printer and press the
> ENTER key to print calibration pass #2.
> Gamma? 3
>
> Thank you. Now insert the page back into the printer and press the
> ENTER key to print calibration pass #3.
>
> Press ENTER to print pass #3 or N to skip...
> Sending calibration pass #3 for red, green, and blue adjustment...
> Calibration pass #3 sent.
>
> Please select the character that corresponds to the correct red,
> green, and blue colors. If the transition point appears to occur
> between two characters, enter both characters.
>
> Red color? 7
> Green color? 7
> Blue color? 7
>
> Thank you. Now insert the page back into the printer and press the
> ENTER key to print the final calibration pass.
>
> Press ENTER to continue...
> Sending calibration pass #4 for visual confirmation...
> Segmentation fault (core dumped)
> --
>
> ----------------------------------------------------------
> Peter Ruskin <[EMAIL PROTECTED]>
> Wrexham, UK KDE - the professionals' choice
> ----------------------------------------------------------
