> Peter Ruskin wrote:
> >
> > HP720C
> > Still not working with cups 1.1.2-22mdk and cups-drivers 0.3.6-12mdk...
> >
> > ESP Printer Calibration Tool v1.0
> > Copyright 1999-2000 by Easy Software Products, All Rights Reserved.
> >
> > Printer name [default]?
> > Resolution [default]? 600x600
> > Media type [default]?
> > Press ENTER to print pass #1 or N to skip...
> > Sending calibration pass #1 for density/saturation levels...
> > Calibration pass #1 sent.
> >
> > Please select the character that corresponds to the black block that
> > is 100aturated (dark) while not bleeding through the paper. If
> > the saturation point appears to occur between two characters, enter
> > both characters.
> >
> > Black density? f
> >
> > Now select the character that corresponds to the yellow block that is
> > 100aturated (dark) while not bleeding through the paper. If the
> > saturation point appears to occur between two characters, enter both
> > characters.
> >
> > Yellow density?
> > Yellow density? f
> >
> > Now select the character that corresponds to the red block that is
> > 100aturated (dark) while not bleeding through the paper. If the
> > saturation point appears to occur between two characters, enter both
> > characters.
> >
> > Red density? f
> >
> > Thank you. Now insert the page back into the printer and press the
> > ENTER key to print calibration pass #2.
> > Gamma? 3
> >
> > Thank you. Now insert the page back into the printer and press the
> > ENTER key to print calibration pass #3.
> >
> > Press ENTER to print pass #3 or N to skip...
> > Sending calibration pass #3 for red, green, and blue adjustment...
> > Calibration pass #3 sent.
> >
> > Please select the character that corresponds to the correct red,
> > green, and blue colors. If the transition point appears to occur
> > between two characters, enter both characters.
> >
> > Red color? 7
> > Green color? 7
> > Blue color? 7
> >
> > Thank you. Now insert the page back into the printer and press the
> > ENTER key to print the final calibration pass.
> >
> > Press ENTER to continue...
> > Sending calibration pass #4 for visual confirmation...
> > Segmentation fault (core dumped)
> > --
On Mon, 18 Sep 2000, Till Kamppeter wrote:
> Did it not print or did only the calibration not work?
>
> Or didn't you find this printer in the printer listing?
>
> The calibration is still alpha, perhaps I will take it out again.
>
> Till
Till,
The printer works fine. It's only the calibration that can't print the
fourth pass, and presumably doesn't save any settings - I'd enter the
settings by hand if I knew where to do it.
Thanks,
Peter
--
------------------------------------------------------
Peter Ruskin <[EMAIL PROTECTED]>
Wrexham, UK KDE - the professionals' choice
------------------------------------------------------
