Peter Ruskin <[EMAIL PROTECTED]> writes:
[...]
> > Esp. is it working with "disk=/dev/hde bios=0x80"?
>
> With "disk=/dev/hde bios=0x80" I just see "LI" on boot.
\item[\raw{LI}] The first stage boot loader was able to load the second
stage boot loader, but has failed to execute it. This can either be
caused by a geometry mismatch or by moving \path{/boot/boot.b} without
running the map installer.
> With "disk=/dev/hde bios=0x80" commented out I get a screenful of "40"s
\item[\raw{L \meta{error} $\ldots$}] The first stage boot loader has been
loaded and started, but it can't load the second stage boot loader.
The two-digit error codes indicate the type of problem. (See also section
\ref{bioserr}.) This condition usually indicates a media failure or a
geometry mismatch (e.g. bad disk parameters, see section \ref{diskgeo}).
\item[\raw{0x40}] ``Seek failure''. This might be a media problem. Try
booting again.
i really don't know, try with:
disk=/dev/hde bios=0x80
disk=/dev/hdf bios=0x81
disk=/dev/hdg bios=0x82
disk=/dev/hgh bios=0x83
disk=/dev/sda bios=0x84
