On Jan 13, 2008 10:08 PM, Jouni Mettälä <[EMAIL PROTECTED]> wrote: > > > > On Jan 12, 2008 7:24 PM, Peter Stuge <[EMAIL PROTECTED]> wrote: > > > > On Sat, Jan 12, 2008 at 02:15:34PM +0200, Jouni Mettälä wrote: > > > LinuxBios booted to filo. Motherboard is abit be6. This is azza/pt-6ibd/ > > > config using http://coreboot.org/AZZA_PT-6IBD_Build_Tutorial. filo > > > config was also from it. > > > > Cool! > > > > FILO doesn't find a hard drive at hda. Do you have one there? > > > > Either way, it would be nice if you could use memtest as payload and > > let it run for a few hours to check that RAM is set up right. > > > > > > //Peter > > > > It now boots with filo. This time with different filo Config file. # means > these lines were commented out. > > #USE_GRUB = 1 > MENULST_TIMEOUT = 6 -> = 10 > VGA_CONSOLE = 1 -> VGA_CONSOLE = 0 > PC_KEYBOARD = 1 -> PC_KEYBOARD = 0 > #SUPPORT_PCI = 1 > #PCI_BRUTE_SCAN = 1 > added > DEBUG_ALL = 1 > > using single 64M chip memtest was ok after 20 minutes. If longer time is > needed then I test new version of memtest. Reading supported motherboards > azza/pt-6ibd/ works also with 64MB it is marked as WIP. > > Keyboard isn't working yet. Tested ps/2 keyboard. Using kernel as boot file > it boots. I can't log in with keyboard or minicom. This could be something > simple I don't now. Writing of boot line works with minicom.
I can confirm. It has been reported by me a while ago: http://www.coreboot.org/pipermail/coreboot/2007-December/028256.html People on IRC tried to help me, but the problem still remains. Did you use flashrom on this board? It didn't work for me, and I had to use uniflash in dos. -- coreboot mailing list [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
