Has anyone been able to boot a SATA drive using FILO on a 690/600 platform?
I keep getting IDE timeouts on detection. I originally thought that it might be
the SATA flash that I am using, but it does the same thing with a standard HDD.
Both devices are SATA 1.5g drives, so maybe my last patch to fall down to 1.5g
is incomplete or broken? I don't have any SATA 2.0 drives around.
I have compared PCI configs between the prop BIOS and CB. From what I can see
all of the settings that need to be the same are.
If someone else could give this a shot it would be appreciated. Any good ideas
where to start trying to debug this would be appreciated also. I have already
turned on debug messages, but the FILO prompt currently wipes them out before I
can grab them so I can't post a log yet.
I have another question dealing with PCI numbering if someone has the time to
answer it.
690/600 SATA is Bus 0: Dev 18: Func 0 in the docs.
How/Why/Where did it get 0:12:0 ? in the OS and in some places in CB(dts)?
Am I mixing two different things up? I would like to know what I am missing.
Thanks,
Dan Lykowski
--
coreboot mailing list: [email protected]
http://www.coreboot.org/mailman/listinfo/coreboot
