samuel wrote: > >>Do you have access to a continuity tester? Please check this > >>connection. > > I do not have access to a continuity tester.
.. > >> * You can insulate the #TBL pin of the flash chip from the > >> corresponding socket contact, and connect #TBL to Vdd. According > >> to the datasheet of SST49LF080A, providing Vih(=Vdd) to #TBL > >> disables write protection on the boot block. > > I guess i can try this... I suppose it won't hurt? Yep, it's a good idea. Bend pin 8 up and make sure it doesn't have contact with the socket, then connect it to pin 32 or 25. (Both VDD) > >>Correct. It is most likely the cause. But - it would also be > >>interesting if you could measure the voltage Samuel, on pin 8 > >>after having run flashrom in any mode. > > I will get a volt meter... What pin should i use as ground? I tried > having a look at page 7 of the LPC data sheet but i didn't see a > ground pin... 16, VSS is ground. Maybe that volt meter also has an ohm meter function. That works well as a continuity tester too - if two points are connected the resistance will be 0.00 ohm. //Peter -- coreboot mailing list: [email protected] http://www.coreboot.org/mailman/listinfo/coreboot
