On Wed, Dec 14, 2016 at 02:05:12PM +0000, Peter Stuge wrote: > sebastien basset wrote:
Hi Peter, > > For flashing board solidpc, > > 1/ plug power supply (without pressing the power button) > > 2/ connect dediprog on j8 connector( with good cable) > > 3/ ./flashrom -p dediprog:voltage=1.8V -w solidrun.rom > > Why 1.8V? Is there a schematic available for this board? Please take a look at this: http://www.solid-run.com/wiki/doku.php?id=products:ibx:software:development:bios Information on page say: Notice that the programmer must drive 1.8v signals; otherwise the main processor might get damaged Best Regards, -- Piotr Król Embedded Systems Consultant http://3mdeb.com | @3mdeb_com -- coreboot mailing list: [email protected] https://www.coreboot.org/mailman/listinfo/coreboot
