Better here, sorry. https://github.com/osresearch/heads/issues/134
Le ven. 23 févr. 2018 00:26, Thierry Laurion <[email protected]> a écrit : > Actually if others of you want to contribute, there is this heads kgpe-d16 > port that permits to flash directly from the heads coreboot payload with > Timothy's patches on the flashrom tools. You may want to take a look here : > https://github.com/flammit/heads/pull/9#issuecomment-362022411 > > Le jeu. 22 févr. 2018 16:37, Timothy Pearson < > [email protected]> a écrit : > >> Actually, for OpenBMC work, hotplugging is often the only way to go. >> Just be very careful to align the pins correctly the first time; you >> don't have a second chance if you misalign the pins and fry the module... >> >> On 02/22/2018 03:22 PM, [email protected] wrote: >> > On 02/17/2018 09:46 AM, Elisenda Cuadros wrote: >> > >> >> Hi, >> >> >> >> Now I trying to use your OpenBMC port. >> >> >> >> I followed the instructions and everything was fine (compiling, >> >> reading and flashing). I waited several minutes after flashing, but >> >> the module didn 't blinked like in the vendor rom, nor did it receive >> >> an ip. >> >> >> >> I halted the system because I thought maybe it needs a cold start. >> >> >> >> After this, the system doesn't boot with the module plugged in. The >> >> fans begin to spin for approximately 1/4 second, but nothing else. >> >> >> >> My two fans (1 cpu & 1 chassis) have 3 pins and are low speed >> (~1000rpm) >> >> >> >> In the case I have to reflash the module, is it possible to hotplug it? >> > Hotplugging is dangerous and not supported, don't do it. >> >> Thank you very much for your support. >> > You can use a test clip to externally flash it via a flashing device >> > (not sure which can do 16 pins though, I would inquire on the flashrom >> > mailinglist) >> > >> > Are you using the latest coreboot? AFAIK coreboot was patched to support >> > OpenBMC, so you need a new version with the patches. >> >> >> -- >> Timothy Pearson >> Raptor Engineering >> +1 (415) 727-8645 (direct line) >> +1 (512) 690-0200 (switchboard) >> https://www.raptorengineering.com >> >> -- >> coreboot mailing list: [email protected] >> https://mail.coreboot.org/mailman/listinfo/coreboot >> >
-- coreboot mailing list: [email protected] https://mail.coreboot.org/mailman/listinfo/coreboot
