----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
One thing to watch for... the originals are flat and if panel changes have been made since the ramshorns were installed, the originals may not clear any new panel protuberances (e.g. DG setting knob) that have been added. Just something to watch for. Greg At 07:20 PM 5/2/02 +0000, Rick Green wrote: >----[Please read http://ercoupers.com/disclaimer.htm before following any >advice in this forum.]---- > >I'm hoping that going back to the original will allow me to GAIN the ten >pounds. I have to do a tight bicep curl to get the full up travel with >the ram's horns. > >Rick > >Greg Bullough wrote: > > At 12:06 AM 5/2/02 +0000, Rick Green wrote: > > >I'm thinking that due to the "extended" reach of the > > >ram's horns, that these might be a different length of > > >shaft. > > > > > >So my question is, does converting from one style to the > > >other require different length shafts? > > > > No, you use the same shaft. (same degree of down-elevator). > > > > However, you may have to lose about ten pounds to get > > full up elevator travel :-) > > > > Greg > > > > (P.S.: I'm not kidding here) > > > > > > > ==^================================================================ This email was sent to: [EMAIL PROTECTED] EASY UNSUBSCRIBE click here: http://topica.com/u/?bz8Sid.bAhN69 Or send an email to: [EMAIL PROTECTED] T O P I C A -- Register now to manage your mail! http://www.topica.com/partner/tag02/register ==^================================================================
<<attachment: winmail.dat>>
