----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Warren; I am not sure that I was saying it right either, but I do know that the cylinder guy said that if you only go to the minus side, that there will often be problems. He had tried the adjustable reamer too, but it apparently did not do the job properly. He even goes so far as to buy all the guides in the maximum oversize. Then puts them in a lathe and turns them to put the valve stem hole precisely in the center. He indicated that he had seen them made new, several thousands out of round or off center or something like that. In any case, it sounds like the current sticking valve problem has been remedied. Lynn Nelsen N99387 52FL __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A The Email You Want. http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
