----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- In a message dated 10/12/00 6:46:28 PM Eastern Daylight Time, [EMAIL PROTECTED] writes:
> Then puts them in a lathe and turns them to put the > valve stem hole precisely in the center. He indicated that he had seen them > made new, several thousands out of round or off center or something like > that. Sounds like the hard way! Usually you install the guide then cut the seat to center it on the guide. You gotta cut the seat anyhow... __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A The Email You Want. http://www.topica.com/t/16 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
