----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
They are listed in the parts manual as AN bolts. I noticed when I looked at them lately (thought I was going to have to take my wings off to replace bearings) that Skyport is now selling NAS close tolerance bolts as replacements for at least some of this stuff, though those that I saw were not for the wing spar ends but for inside the fuselage where the spars attach. They are pretty expensive. I don't know what kind of bolt they sell for the spars. -----Original Message----- From: [EMAIL PROTECTED] <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>; [EMAIL PROTECTED] <[EMAIL PROTECTED]>; [email protected] <[email protected]> Date: Tuesday, December 19, 2000 1:07 PM Subject: Re: [COUPERS] loose wing >----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- > >Dick, > >I think you are correct...I think the correct wing attachment bolts are >"Close Tollerance Bolts", that may have been replaced by standard sized >bolts..thus the play. > >Harry > >__________________________________________________ >To unsubscribe from this list please send mailto:[EMAIL PROTECTED] > >___________________________________________________________ >T O P I C A http://www.topica.com/t/17 >Newsletters, Tips and Discussions on Your Favorite Topics > __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A http://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
