----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
When I discovered that the bolts used on both Coupes I have had were standard bolts I checked the parts manual. The bolts specified are AN10-24 which are not close tolerance bolts. I have only pulled one set of wings however on the set I did pull the bolts were an interference fit with significant force required to remove them. If the holes in the wing fittings are enlarged I wonder if it would be possible to have a set of wing bolts chromed to increase their diameter. If this would have adversely affect the strength of the bolts then possibly machining a pair of bolts with oversize shanks might be a solution. I sure would worry about a loose fit fretting and getting worse hour by hour. Cheers: Paul N2273H __________________________________________________ To unsubscribe from this list please send mailto:[EMAIL PROTECTED] ___________________________________________________________ T O P I C A http://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics
<<attachment: winmail.dat>>
