What the hell ever happened to customer service? No offense, but this is a pretty asinine and useless reply to the rather specific questions I asked. I think I'd rather not deal with these people. Can someone else make a good recommendation for parts online somewhere? If not, I'll just go to my local dealer, they at least take more than ten seconds to try and help me with stuff.
Fred...who's STILL leaking coolant, no help to the wonderful people at Majestic Honda. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Tuesday, May 21, 2002 3:53 PM To: Fred Bocskor Subject: Re: Parts questions: 1989 CRX Si You can locate these parts under "HEATER CONTROL" category. Here's the link..................... http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.js pinputstate=5&catcgry1=CRX&catcgry2=1989&catcgry3=2DR+SI&catcg ry4=KA5MT&catcgry5=HEATER+CONTROL Thank you for visiting Majestic Honda. Please let us know if there is anything else we can do. Thank you ---- Original message ---- >Date: Mon, 20 May 2002 23:31:18 -0500 >From: "Fred Bocskor" <[EMAIL PROTECTED]> >Subject: Parts questions: 1989 CRX Si >To: <[EMAIL PROTECTED]> > >Hi there, I'm wondering if you can provide part numbers for what I need here >(they're all for an 89 CRX Si): > >My interior temperature adjustment knob no longer works. What happened is >one of the little plastic molded pieces that holds the outer sleeve of the >cable broke, so I need to replace that part of it. Everything else seems >fine. I was wondering if there were a single part there I could replace, or >do I need to replace most of the assembly? I also need one of the screws >that holds the back plate of the adjustment knob in place (I'll try >describe, since that seems vague: if you take the knob off, you see the >little silverish adjustment screw...the part that it is a part of gets >screwed into the back of the assembly to hold it in place. I lost one of the >screws). > >Also, I have a JDM-spec B16A (first gen 89-92 Integra XSi or CRX SiR) motor >in my car and need to replace the inlet and outlet hoses for the EACV, along >with the clamps for them. The picture for the CRX parts seem a bit off from >what I need. The u-shaped hose goes from the left side of the EACV (when >looking at the engine from the front) to just underneath the throttle body. >I'm guessing I would need the part from either a Del Sol VTEC or a 99/00 >Civic Si. Any idea which one would work better? The other hose comes from >the right side of the EACV and goes into the block somewhere beneath the >intake manifold. > >Any help is appreciated...I'd like to stop dumping coolant all over the >driveway =) > >Thanks...Fred >
