Just go to your local autoparts store and get some hose thats the same size. Cut it to size and clamp it down. You don't need a pre-bent piece if you're dumping coolant on the street.
-Kristian On Tue, 21 May 2002, Fred Bocskor wrote: > What the hell ever happened to customer service? No offense, but this is a > pretty asinine and useless reply to the rather specific questions I asked. I > think I'd rather not deal with these people. Can someone else make a good > recommendation for parts online somewhere? If not, I'll just go to my local > dealer, they at least take more than ten seconds to try and help me with > stuff. > > Fred...who's STILL leaking coolant, no help to the wonderful people at > Majestic Honda. > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, May 21, 2002 3:53 PM > To: Fred Bocskor > Subject: Re: Parts questions: 1989 CRX Si > > > You can locate these parts under "HEATER CONTROL" category. > Here's the link..................... > > > http://www.hondaautomotiveparts.com/auto/jsp/mws/prddisplay.js > pinputstate=5&catcgry1=CRX&catcgry2=1989&catcgry3=2DR+SI&catcg > ry4=KA5MT&catcgry5=HEATER+CONTROL > > Thank you for visiting Majestic Honda. Please let us know if > there is anything else we can do. > > > Thank you > > > > > > ---- Original message ---- > >Date: Mon, 20 May 2002 23:31:18 -0500 > >From: "Fred Bocskor" <[EMAIL PROTECTED]> > >Subject: Parts questions: 1989 CRX Si > >To: <[EMAIL PROTECTED]> > > > >Hi there, I'm wondering if you can provide part numbers for > what I need here > >(they're all for an 89 CRX Si): > > > >My interior temperature adjustment knob no longer works. > What happened is > >one of the little plastic molded pieces that holds the outer > sleeve of the > >cable broke, so I need to replace that part of it. > Everything else seems > >fine. I was wondering if there were a single part there I > could replace, or > >do I need to replace most of the assembly? I also need one > of the screws > >that holds the back plate of the adjustment knob in place > (I'll try > >describe, since that seems vague: if you take the knob off, > you see the > >little silverish adjustment screw...the part that it is a > part of gets > >screwed into the back of the assembly to hold it in place. I > lost one of the > >screws). > > > >Also, I have a JDM-spec B16A (first gen 89-92 Integra XSi or > CRX SiR) motor > >in my car and need to replace the inlet and outlet hoses for > the EACV, along > >with the clamps for them. The picture for the CRX parts seem > a bit off from > >what I need. The u-shaped hose goes from the left side of > the EACV (when > >looking at the engine from the front) to just underneath the > throttle body. > >I'm guessing I would need the part from either a Del Sol > VTEC or a 99/00 > >Civic Si. Any idea which one would work better? The other > hose comes from > >the right side of the EACV and goes into the block somewhere > beneath the > >intake manifold. > > > >Any help is appreciated...I'd like to stop dumping coolant > all over the > >driveway =) > > > >Thanks...Fred > > > >
