If those are slotted brembos, I think you're supposed to only use metallic brake pads. I'm not sure if that would cause what you're talking about, but something doesn't seem right. If you bought them locally, I'd go back to the store and have them check the part numbers.
-Kristian On Sun, 29 Sep 2002, George Freeman wrote: > Okay, > > I just got done doing a long list of jobs to the 'Rex yesterday & today. > Replaced the rear bearings (finally) and it drives nice & quiet now. > That's the good news, now the bad news: I replaced the front rotors > with Brembo's and slapped in some ceramic pads as well and the rotors > are scarring! > > When I was installing the rotors, the calipers didn't want to sit > properly over the Brembo's in that the outer part of the caliper was > rubbing the rotor. I pulled the caliper and got out the Dremel and > ground down about a millimeter of mostly rust, then it cleared no > problem. After the first drive, I heard a *slight* rubbing noise which > I figured to be break-in sounds, then I checked the rotors and noticed > two distinct scars in the outer side of each rotor about 3/4 away from > the inner part of the rotor, not exactly where the caliper was > originally rubbing (inside's fine on both BTW). What the hell? Are the > Brembos too thick?! Have I destroyed the rotors in the 20 or so miles I > drove it today? > > > > George > '89 DX-Hybrid-D16Z6, 124k miles > "Seats, Suspension, Engine, MSD, next=dyno" > >
