On Jul 6, 2010, at 6:33 PM, Sharon wrote:
> I don't have any error messages. A healthy popping noise
Popping noise?
> and then the
> file doesn't load. I have it set up on Linux and if I click on the .py
> file it runs and the gui shows up and the buttons can be pressed. Just
> don't seem to be able to load the gui to make changes to it. I can load
> the Test-code.py and make changes to that just not the cdxml. Any
> ideas.
So let's make sure what the steps you are following are. You run the
Class Designer, and when it starts up it presents you with a dialog that has a
button near the top that says 'Open Saved Class'. When you click that button,
you get the file selection dialog, and select the saved .cdxml file. But after
you click 'OK', nothing happens. Is that correct?
-- Ed Leafe
_______________________________________________
Post Messages to: [email protected]
Subscription Maintenance: http://leafe.com/mailman/listinfo/dabo-users
Searchable Archives: http://leafe.com/archives/search/dabo-users
This message:
http://leafe.com/archives/byMID/[email protected]
