Now I think it has to do with the combination Filmic and Exposure.
I modified Exposure, than turned on Filmic preset EV 10, then went back
to the Exposure module. Changing the Exposure + or - makes the images
suddenly jump to a much darker state. Use the mouse wheel and try it.
I can't believe this is normal. but perhaps it is? That means Filmic
could only be used at the end of editing?
It happens with Nikon and Fuji raw images.
Op 14-03-19 om 16:18 schreef Remco Viëtor:
On jeudi 14 mars 2019 15:42:01 CET Kneops wrote:
I just updated DT to 2.6.1, tried one of the Filmic presets, turning it
on an off and on etc.
Doing this, the images become too dark suddenly (bottom half of the
screenshot), then the next time I turn it on it's normal again (top half
of the image) etc. I can do this multiple times and it will keep on
changing from normal to too dark and back to normal. Just by turning the
module on.off.on.off.on etc.
____________________________________________________________________________
darktable user mailing list
to unsubscribe send a mail to [email protected]
Depending on the parameters of the filmic module, that can be perfectly
normal:
e.g. a strong preference for the shadows will brighten those considerably,
same when you lower the halfway luminosity, or play with the black point
slider.
____________________________________________________________________________
darktable user mailing list
to unsubscribe send a mail to [email protected]
____________________________________________________________________________
darktable user mailing list
to unsubscribe send a mail to [email protected]
