On 26/2/22 01:05, Hervé Sainct wrote:
What about re-opening one of the image in DT and looking at the
'history', unfolding the menue if need be? What's the last operation?
What if you regress one stap back?
H.
Le 25/02/2022 à 14:09, Andrew Greig a écrit :
Hi All,
I finished processing 358 images from yesterday's shoot, and Exported
all of the images as Full size jpgs. They look great. Next I
watermarked the full set for Export to Model Mayhem as 2000px x
2000px and less than 1Mb. I checked a couple of images, and they
looked as if a neutral density filter had been laid over each of
them, so I checked the lot, and all of them had the same darkening,
rendering them unusable. It appears that all of my settings have been
reset to default values. As soon as the full size images finished, I
started exporting the Proofs. So in the three minutes between
watermarking and then exporting the values were returned to default
values. 8 hours of my time just up in smoke. What could cause this?
Exposure, Perspective Correction, Crop, Filmic, all reset.
--
____________________________________________________________________________
darktable user mailing list to unsubscribe send a mail to
[email protected]
--
[email protected]
____________________________________________________________________________
darktable user mailing list to unsubscribe send a mail to
[email protected]
Thanks Herve for responding, I did that and found that every module
except the defaults had gone back to the default state, as if I had just
imported them. All work gone. But I have been advised to change an
export settin and I am now confident to commence work again.
____________________________________________________________________________
darktable user mailing list
to unsubscribe send a mail to [email protected]
