I got a "DONE" message after sending crc-32 and ubl, so I guess the crc32 check is okay.. but it then it still goes to "BOOTME.." state.. One thing I wonder.. for the UBL-4byte ARM physical start address field in ACK sequence.. I think this should be the starting address of the UBL.. hence I put "0020".. However, RBL always give "BAD ADDR" sequence if I use this value.. Known value to be ok is if left the 2 LSB as zeros.. like "0200", "xx00".. but It's not the value where UBL should be started from (0x20).. Anybody would advice the actual use of this UBL-4byte ARM start address field?
Did you write your own UBL? Or which UBL are you using? Regards, Carlos _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
