There was a change made in DSP/BIOS Link (ARM<->DSP transport layer beneath codec engine) between the DVEVM v1.00 and DVEVM v1.10 release.
Notifying users about this change slipped through the cracks on the release notes and isn't documented in the getting started guide or the dvevmupdates website. Not much of a consolation prize but it is identified in the printed quick start guides shipped in the DVSDK - that's how I know about it. Looks like providing info about this on the dvevmupdate site and along with a release note addenda to help communicate this and other errata might help. Regards, Thom -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Tuesday, September 26, 2006 8:36 PM To: [email protected] Subject: RE: Problem with demos in DVEVM 1.10 update >> You may need to change the switch position of SW3-4 That fixed it - THANKS! (I moved SW3-4 to the "on" position) According to the DVEVM docs, this switch controls whether the ARM boots the DSP or the DSP 'self boots'. Setting this switch to "1" says that the DSP should 'self boot'. I suppose the old version of the demos (or the kernel that came with them) controlled the DSP boot, where the new versions don't anymore? Did I miss this somewhere in the release notes??? Thanks, - Paul _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
