It is the problem SW3-4 has to be set "ON" position. It is never documented as other people has pointed out.
thanks much, alan --- Alan Li <[EMAIL PROTECTED]> wrote: > It is the same "failed to open Engine error" for > decode demo. This is only happen when I update to > DVEVM 1.10 release (I believe I did a clean update). > BTW, What is SW304 switch to On position > requirement? > I never did check this switch thing for my current > DVEVM 1.0 release and it works fine before. thanks, > > alan > > --- "Monk, Roger" <[EMAIL PROTECTED]> wrote: > > > Did you check that SW3-4 is in the "on" position? > > > > Is the decode only demo working ok? > > > > ~roger > > > > -----Original Message----- > > From: > > > [EMAIL PROTECTED] > > > [mailto:[EMAIL PROTECTED] > > On > > Behalf Of Alan Li > > Sent: 28 September 2006 23:21 > > To: [email protected] > > Subject: DVEVM 1.10 Encode Demo > > > > Hi, > > > > I upgraded to DVEVM 1.10 release. I believe i did > a > > clean upgrade and use the coming uImage to do a > TFTP > > boot. Once I compiled the all the demo codes and > > launch the encode or encodedecode demo, it always > > fails to open the engine (Engine_open call) > failed. > > Does anyone have similar problem or any > suggestion? > > thanks, > > > > alan > > _______________________________________________ > > Davinci-linux-open-source mailing list > > [email protected] > > > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > > > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
