I do this
1) # create an 8MB USB file
dd bs=1M count=8
if=/dev/zero of=/opt/usbfile
2) # run fdisk
to set S=8,H=16,C=128 and then create and write an 8MB partation to the
/opt/usbfile created by DD
3) #start USB Gadget
modprobe
g_file_storage file=/opt/usbfile
4) Plug board in to WindowsXP host. I can see the
USB Mass storage device appear in the USB section of device manager. I
can see the linux file-stor gadget usb device appear under DiskDrives
in device manager.
Cant seem to find it
anywhere else. No drive letter assignment
Thanks for
any advice
-----Original Message-----
From: Diego Dompe <[EMAIL PROTECTED]>
To: Steve Spano <[EMAIL PROTECTED]>
Cc: [email protected]
Date: Wed, 8 Nov 2006 07:53:15 -0600
Subject: Re: ### USB Mass Storage
Hi Steve,
> The PC see's the board as a mass stoarge device. I see a Linux File-
> Store disk drive in the device manager - but no drive letter
> appears anywhere in Windows.
>
> I have done the DD + FDisk + modprobe to get it up and running.
>
> Any ideas?
Which command arguments are you using to install the module of file
storage?
Diego Dompe
RidgeRun Engineering
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
