> All, > > I have met a problem when run DVEVM 1.10 demo---"encodedecode". When I run > this demo in 256MB memory, everything is OK, but when I shrink the memory > into 64MB I met a problem with codec server. I am sure I have use a > correct memory map, and recompile CMEM, DSPLINK with a right memory > config. Following is my debug message: ( I use 28MB for Linux). > > ************************************************************************** > ************************************************************************** > ********** > [EMAIL PROTECTED]:~/dvevm_1_10_28M# sh ./loadmodules.sh > cmemk: module license '(c) Texas Instruments' taints kernel. > cmem initialized 4 pools between 0x81c00000 and 0x82400000 > dsplinkk: no version for "struct_module" found: kernel tainted. > DDR_START 0x83600000 DDR_SIZE 0x800000 > > > [EMAIL PROTECTED]:~/dvevm_1_10_28M# ./encodedecoded > Encodedecode Debug: NTSC selected > Encodedecode demo started. > Encodedecode Debug: Codec Engine initialized > Encodedecode Debug: Logging initialized > Encodedecode Debug: Rendezvous opened for 3 threads > Encodedecode Debug: Display buffer 0 mapped to address 0x42b42000 > Encodedecode Debug: Display buffer 1 mapped to address 0x42beac00 > Encodedecode Debug: Display buffer 2 mapped to address 0x42c93800 > Encodedecode Debug: Video display device initialized. > Encodedecode Debug: Set the capture input to id 0 > Encodedecode Debug: OSD successfully initialized > Encodedecode Debug: OSD transparency initialized > Encodedecode Debug: Codec Engine opened in control thread > Encodedecode Debug: NTSC camera detected > Capturing 720x480 video (cropped to 720x480) > Encodedecode Debug: 3 capture buffers were successfully allocated. > Encodedecode Debug: Capture buffer 0 mapped to address 0x42e90000 > Encodedecode Debug: Capture buffer 1 mapped to address 0x42f68000 > Encodedecode Debug: Capture buffer 2 mapped to address 0x43040000 > Encodedecode Debug: Video capture initialized and started > Encodedecode Debug: Codec Engine opened in video thread > Encodedecode Error: Can't open decode algorithm: h264 > Encodedecode Debug: Entering display main loop. > Encodedecode Debug: MSP430 library initialized > Encodedecode Debug: User interface created > Encodedecode Debug: Entering control main loop. > > ************************************************************************** > ************************************************************************** > *************** > > George Gu > (Xiangyu Gu) > Wintech Digital System Co. > Beijing, China > Ph: 8610-8278-2828 ext.168 > Fax: 8610-8278-0028 > http://www.wintechdigtal.com > ----------------------------
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
