OK, I followed the instructions exactly (per postings to group) to update my
DVEVM to version 1.10 but I still have problems. I used restore_1_10_00_30.tar
to update the filesystem in /dev/hda1; I used uImage in the same restore tar
file to update the kernel at 0x02050000; I used u-boot.bin in
u-boot-upgrade.tar to upgrade u-boot at 0x02000000; and I flipped the S3-4
switch to "on". Here are my problems:
1) When the kernel boots up, I see the following ethernet warning:
NET: Registered protocol family 10
IPv6 over IPv4 tunneling driver
eth0: duplicate address detected!
Now the ethernet interface is very slow (down to 8Kb/s when using the wget
command); I don't know why I'm having this problem; the only thing connected to
the DaVinci board my Fedora 4 PC and I've verified the address is not the same
as that of the board.
2) When the demo screen shows up, I can't move the cursor on the remote control
to select "Encode", "Decode", or "Third Party ...", it stays at "Encode +
Decode" only.
Can someone please help? Am I doing something wrong. Thanks!
Regards,
Andy
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
