Oops, never mind, I see the driver in 1.10's kernel (ti_davinci_emac subdirectory was removed and replaced by davinci_emac* files in
the drivers/net directory). I'm just going crazy over this networking issue! =( ----- Original Message ---- From: "[EMAIL PROTECTED]" <[EMAIL PROTECTED]> To: [email protected] Sent: Tuesday, December 5, 2006 7:59:22 PM Subject: Re: Problems after updating to DVEVM 1.10 Hi, I just did a difference listing between the kernel (2.6.10_mvl402) in DVEVM version 1.00 and the kernel (2.6.10_mvl401-davinci_evm) in DVEVM version 1.10 and found that the ethernet ti_davinci_emac driver doesn't exist in version 1.10. Could this be why I'm getting the duplicate address issue with version 1.10 kernel? What driver is it using in 1.10? The network interface (eth0) in version 1.10 keeps giving me errors (may due to the ICMPv6 NA duplicate address issue). I guess I may have to use the kernel source of 1.00 in version 1.10. ----- Original Message ---- From: "[EMAIL PROTECTED]" <[EMAIL PROTECTED]> To: [email protected] Sent: Tuesday, December 5, 2006 5:41:33 PM Subject: Re: Problems after updating to DVEVM 1.10 I got some more details on my problems below. Please disregard problem 2 because I'm able to run the demos fine via the shell. For problem number 1, it seems like the ethernet driver changed from 1.00 to 1.10. The error I'm getting is "ICMPv6 NA: someone advertises our address on eth0!". I googled it and found a thread for another ethernet driver that mentioned somehow the interface is seeing itself and complaining of a duplicate address: http://www.bughost.org/bugzilla/show_bug.cgi?id=265. Anyone see this problem before? Regards, Andy ----- Original Message ---- From: "[EMAIL PROTECTED]" <[EMAIL PROTECTED]> To: [email protected] Sent: Tuesday, December 5, 2006 1:56:04 PM Subject: Problems after updating to DVEVM 1.10 OK, I followed the instructions exactly (per postings to group) to update my DVEVM to version 1.10 but I still have problems. I used restore_1_10_00_30.tar to update the filesystem in /dev/hda1; I used uImage in the same restore tar file to update the kernel at 0x02050000; I used u-boot.bin in u-boot-upgrade.tar to upgrade u-boot at 0x02000000; and I flipped the S3-4 switch to "on". Here are my problems: 1) When the kernel boots up, I see the following ethernet warning: NET: Registered protocol family 10 IPv6 over IPv4 tunneling driver eth0: duplicate address detected! Now the ethernet interface is very slow (down to 8Kb/s when using the wget command); I don't know why I'm having this problem; the only thing connected to the DaVinci board my Fedora 4 PC and I've verified the address is not the same as that of the board. 2) When the demo screen shows up, I can't move the cursor on the remote control to select "Encode", "Decode", or "Third Party ...", it stays at "Encode + Decode" only. Can someone please help? Am I doing something wrong. Thanks! Regards, Andy _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
