> i followed the Ti document "Booting Davinci EVM from NAND FLASH" setuping my > board but when i load the flashwriter_nand.out > I will get followed error messages in CCS
Which GEL file are you using? The one shipped with CCS doesn't seem to work. Try using the one from Spectrum Digital: http://c6000.spectrumdigital.com/davincievm/revd/ Cheers, Lorenzo Thank you Lorenzo But when I used the GEL file you said , i get the following error messages. Trouble Setting Breakpoint with the Action "Terminate GEL_Go()" at 0x880079cc: Error 0x00000008/-1086 Error during: Break Point, Cannot set/verify breakpoint at 0x880079CC Sequence ID: 7 Error Code: -1086 Error Class: 0x00000008 BreakpointManager: Retrying with a Hardware breakpoint Trouble Setting Breakpoint with the Action "Process CIO" at 0x88007f50: Error 0x00000008/-1086 Error during: Break Point, Cannot set/verify breakpoint at 0x88007F50 Sequence ID: 7 Error Code: -1086 Error Class: 0x00000008 BreakpointManager: Retrying with a Hardware breakpoint Trouble Setting Breakpoint with the Action "Terminate Program Execution" at 0x8800746c: Error 0x00000008/-1086 Error during: Break Point, Cannot set/verify breakpoint at 0x8800746C Sequence ID: 7 Error Code: -1086 Error Class: 0x00000008 BreakpointManager: Retrying with a Hardware breakpoint Trouble Setting Breakpoint with the Action "Terminate Program Execution" at 0x8800746c: Error 0x00000008/-2047 Error during: Break Point, Unable to set hardware breakpoint at 0x8800746C. All hardware breakpoints are already in use. Some hardware breakpoints may be used by analysis. Sequence ID: 7 Error Code: -2047 Error Class: 0x00000008 I do'nt know what's going on. It always said data verification at address 0x88019100,0x88000000,0x88007FF0. Thanks Dan -- Open WebMail Project (http://openwebmail.org) _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
