I downloaded the git sources by using git-clone git://source.mvista.com/git/linux-davinci-2.6.git i ran ARCH=arm CROSS_COMPILE=arm_v5t_le- make distclean then ARCH=arm CROSS_COMPILE=arm_v5t_le- make davinci_evm_dm644x_defconfig then ARCH=arm CROSS_COMPILE=arm_v5t_le- make uImage I am using the Montavista compilation tools from Montavista's site. I used tftpboot to boot off this image, and the board gets stuck after "Uncompressing Linux ... done, booting the kernel." I have only the ethernet, serial, and power cable plugged in.
This board works fine when using the TI 2.6.10 kernel. Output: ## Booting image at 80700000 ... Image Name: Linux-2.6.20-omap1-ge7255f31-dir Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1374944 Bytes = 1.3 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK OK Starting kernel ... Uncompressing Linux............................................................. .............................. done, booting the kernel. Thanx for any help, Nachum Kanovsky Senior Software/Hardware Engineer Manager of Infrastructures Mango DSP Ltd. E-mail: [EMAIL PROTECTED] Work: +972 2 588 5039 Cell: +972 547 508 121 Favorite Quote: Mal: "Well, my days of not taking you seriously are certainly coming to a middle..." _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
