Is the uboot from TI's dvevmupdate site the latest bootloader for the EVM? Or is there another perhaps git version somewhere?
It also appears that the patch is meant to solve the problem at the INIT prompt, I am not getting near there. The "Set default pclk frequency" menu option doesn't exist, perhaps b/c I have the system type set to TI DaVinci. I have also found some compilation problems with certain configurations, like when I remove the I2C_Expander option the copmile fails not finding i2c_davinci_write function. Is there somewhere that I should submit bug reports on this kind of thing? Thanx, Nachum Kanovsky Senior Software/Hardware Engineer Manager of Infrastructures Mango DSP Ltd. E-mail: [EMAIL PROTECTED] Work: +972 2 588 5039 Cell: +972 547 508 121 Favorite Quote: Mal: "Well, my days of not taking you seriously are certainly coming to a middle..." -----Original Message----- From: Peter Wippich [mailto:[EMAIL PROTECTED] Sent: Tuesday, March 13, 2007 12:34 PM To: Nachum Kanovsky Cc: [email protected] Subject: Re: git sources - davinci evm doesn't boot Hi, a) make sure you have a new boot loader installed b) check the serial driver patch posted here from time to time Good luck, Peter On Tue, 13 Mar 2007, Nachum Kanovsky wrote: > I downloaded the git sources by using > git-clone git://source.mvista.com/git/linux-davinci-2.6.git > i ran ARCH=arm CROSS_COMPILE=arm_v5t_le- make distclean then ARCH=arm > CROSS_COMPILE=arm_v5t_le- make davinci_evm_dm644x_defconfig then > ARCH=arm CROSS_COMPILE=arm_v5t_le- make uImage I am using the > Montavista compilation tools from Montavista's site. > I used tftpboot to boot off this image, and the board gets stuck after > "Uncompressing Linux ... done, booting the kernel." > I have only the ethernet, serial, and power cable plugged in. > > This board works fine when using the TI 2.6.10 kernel. > > Output: > > ## Booting image at 80700000 ... > Image Name: Linux-2.6.20-omap1-ge7255f31-dir > Image Type: ARM Linux Kernel Image (uncompressed) > Data Size: 1374944 Bytes = 1.3 MB > Load Address: 80008000 > Entry Point: 80008000 > Verifying Checksum ... OK > OK > > Starting kernel ... > > Uncompressing > Linux............................................................. > .............................. done, booting the kernel. > > Thanx for any help, > > Nachum Kanovsky > Senior Software/Hardware Engineer > Manager of Infrastructures > Mango DSP Ltd. > E-mail: [EMAIL PROTECTED] > Work: +972 2 588 5039 > Cell: +972 547 508 121 > > Favorite Quote: > Mal: "Well, my days of not taking you seriously are certainly coming > to a middle..." > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > | Peter Wippich Voice: +49 30 46776411 | | G&W Instruments GmbH fax: +49 30 46776419 | | Gustav-Meyer-Allee 25, Geb. 12 Email: [EMAIL PROTECTED] | | D-13355 Berlin / Germany | _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
