Hi All
Has anyone successfully replaced UBL using the DVFlasher tool. I can
successfully replace U-Boot but when I try to replace UBL the DVFlasher
complains that the U-Boot file is in use.
At the XP DOS prompt I type :
dvflasher_1_12 -v -p "COM1" -fnandsrec -useMyUBL ubl_davinci_nand.bin
new_u_boot.srec
the flasher responds...
-----------------------------------------------------
TI DVFlasher Host Program for DM644x
(C) 2007, Texas Instruments, Inc.
-----------------------------------------------------
Flashing NAND with ubl_davinci_nand.bin and new_u_boot.srec.
Attempting to connect to device COM1...
Press any key to end this program at any time.
Waiting for DVEVM...
DVEVM: BO? BOOTME
BOOTME commmand received. Returning ACK and header...
ACK command sent. Waiting for BEGIN command...
DVEVM: BEGIN
BEGIN commmand received. Sending CRC table...
CRC table sent. Waiting for DONE...
DVEVM: DONE
DONE received. Sending the UART UBL file...
DVEVM: DONE
DONE received. UART UBL file was accepted.
UART UBL Transmitted successfully.
DVEVM: TI UBL Version: 1.12, Flash type: NAND
DVEVM: Booting PSP Boot Loader
DVEVM: PSPBootMode = UART
The process cannot access the file '<path>/new_u_boot.srec' because it
is being used by another process.
Interfacing to the DVEVM via UART failed.
Please reset or power-cycle the board and try again...
It's complaining that the file new-u_boot.srec is in use. It isn't. I
can delete it, rename it, flash it without useMyUBL.
Have I misunderstood how to do this ? Anyone else seen it ?
Regards
Paul Jackson
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
