Hai,
I am working on Davinci DVEVM, i want to connect my CCS v3.3 to the
target board through the jtag emulator ' XDS510PP'.
But whe i am trying to connect my board that has given some errors.
But its working fine when i am in NOR Flash.
I follow these settings,
*
Set J4 jumper (circled in yellow in Figure 1) to NAND
*
Set S3 red switch (circled in green in Figure 1) to
0000111110, where 1=on and 0 =off.
Anyone can tell me the procedure for ARM & DSP when i am in NAND mode
Thanks and Regards,
Rajaram M
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain proprietary, confidential or privileged information. If you are not the
intended recipient, you should not disseminate, distribute or copy this e-mail.
Please notify the sender immediately and destroy all copies of this message and
any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should
check this email and any attachments for the presence of viruses. The company
accepts no liability for any damage caused by any virus transmitted by this
email.
www.wipro.com_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
