Rajaram,
Can you please specify the errors you are getting when trying to connect CCS to the board in NAND mode? To set the board into UART boot mode for nand you should "With the DM644x board powered off set the J4 jumper to NAND and set the S3 red switch to 1100111110 where 1=on and 0=off." To set the board to boot NAND you should "Set the S3 red switch to 0000111110 where 1=on and 0=off" as you indicated below. Sincerely, Chase Maupin Software Applications Catalog DSP Products e-mail: [EMAIL PROTECTED] phone: (281) 274-3285 ________________________________ From: [EMAIL PROTECTED] om [mailto:[EMAIL PROTECTED] ncidsp.com] On Behalf Of [EMAIL PROTECTED] Sent: Monday, December 10, 2007 6:47 AM To: [email protected] Subject: Help Required : Could not connect CCS tool when in NAND - UART modeDVEVM Board Hai, I am working on Davinci DVEVM, i want to connect my CCS v3.3 to the target board through the jtag emulator ' XDS510PP'. But whe i am trying to connect my board that has given some errors. But its working fine when i am in NOR Flash. I follow these settings, * Set J4 jumper (circled in yellow in Figure 1) to NAND * Set S3 red switch (circled in green in Figure 1) to 0000111110, where 1=on and 0 =off. Anyone can tell me the procedure for ARM & DSP when i am in NAND mode Thanks and Regards, Rajaram M The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments. WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email. www.wipro.com
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
