Hi all, So, I am still using DM355's GPIO6 for interrupt (http://linux.omap.com/pipermail/davinci-linux-open-source/2008-March/005530.html). The old problem is still there and I use software to reject the raising edge. But now, I meet a strange problem, when the board is powered on, the GPIO6 interrupt works well. But after about 3-4 minutes, it stops receiving interrupt signal, regardless of the GPIO6 interrupt function is being used or not (after the board is powered on). With a scope, I can see the interrupt signal is still operating, but by adding a printk in irq_hanle function, I see that the board no longer runs to that function. Has any one have a similar experience? I would be very appreciated if you could share the way you fixed it. Viet Hoang.
Send instant messages to your online friends http://uk.messenger.yahoo.com _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
