Sami,
There is supposed to be a program coming from TI to reload a dm355 EVM
from the UART. It was supposed to be released around a month ago, but I
haven't heard anything from my contact at TI about it. So either it's
behind schedule or a low priority item.
If you have access to a BDI2000 JTAG programmer, it's possible to reload
the NAND with it in spite of the fact that the BDI doesn't write to NAND
flash directly. Let me know if you need help with that.
Jeff
Sami Bouraoui wrote:
Hello,
I tried to install u-boot via u-boot on the dm355 EVM but I must have made
a mistake somewhere and the EVM doesn't launch u-boot anymore. I wanted to
know if it is possible to install u-boot without using JTAG or CCS. Ideally,
I would like to install UBL and u-boot using UART. Does anyone know if this
is possible on dm355?
Thanks for your help.
Sami
--
Jeff Cooper // senior embedded software engineer
LOGIC // engineering design services
411 Washington Ave. N. Suite 400
Minneapolis, MN 55401
T // 612.436.5176
F // 612.672.9489
[EMAIL PROTECTED]
www.logicpd.com
/ / / / / / / / / / / / / / / / / / / / / / / / / / / /
This message (including any attachments) contains confidential
information intended for a specific individual and purpose, and
is protected by law. If you are not the intended recipient, you
should delete this message and are hereby notified that any
disclosure, copying, distribution, or other use of this message,
or the taking of any action based on it, is strictly prohibited.
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
