I can`t connect to ARM. This my problem. I find similar problem in http://www.mail-archive.com/[email protected]/msg00388.html But where I can set emulator speed to 100 (is this mean 100Hz???)???
On Fri, 2008-07-25 at 18:50 +0200, Albert Burbea wrote: > Hi > you have to do the following > 1. first connect to the ARM and run the gel script on it > This will release DSP from reset > 2. connect to the DSP > Good luck > Albert > > > On 7/24/08, SergA <[EMAIL PROTECTED]> wrote: > Hi All. > > Need help. > I try to connect to my boards 6446 and 6467 throw JTAG > XDS510PP+. > While I try it with DSP it is ok. > But when I try connect to ARM, CCS says: > Error connecting to the target: > Error 0x80002200/-140 > Fatal Error during: OCS, Control, > Error generated by SD scan controller module > > > > When I try connect to ARM of evmDM6467 the CCS says: > Error connecting to the target: > Error 0x80002200/-140 > Fatal Error during: OCS, Control, > Error generated by SD scan controller module > > Error: > Error 0xA0002020/-1044 > Error during: Execution, Control, > Device driver: Cannot acquire emulator process > Possible conflict for device driver usage > > > What I do wrong??? > > _______________________________________________ > Davinci-linux-open-source mailing list > [email protected] > http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source > > > > -- > Albert Burbea > Harishonim 8 > Ramat Gan 52502, Israel > Tel/Fax + 972-3-7526016 > Mobile: +972-52-3541842 _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
