Hi,
Can you try getting the mode set on the Output after running the application? You can get the current mode by following command. cat /sys/class/davinci_display/ch0/mode Thanks, Brijesh Jadav -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of SergA Sent: Monday, August 11, 2008 5:06 PM To: [email protected] Subject: HD display on DM6467 evm Hi. I try to test capture and display on DM6467 evm. I use saMmapLoopback and saUserPtrLoopback tests. If I connect to capture composite SD resolution in, and also composite out to display: its work fine. Then I connect in component 720p signal. Test is going, but there is nothing (my hdtv tell that there is no input signal) on component out. Also I dump captured frames, and this ok, there is stream that I give in evm. What is wrong? Best regards. Anton Sergeev _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
_______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
