Hello All,
Currently I am working for customized board, hence updating UBL & U-boot
for the new target board other than EVM.
Is there any customization required for the GEL file to be used in CCS.
If any body has attempted to customize it for a new target board, please
share your opinion & procedure.
Thanks a lot in advance.
Regards,
Prabhaharan.R
DISCLAIMER:
-----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended
for the named recipient(s) only.
It shall not attach any liability on the originator or HCL or its affiliates.
Any views or opinions presented in
this email are solely those of the author and may not necessarily reflect the
opinions of HCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification,
distribution and / or publication of
this message without the prior written consent of the author of this e-mail is
strictly prohibited. If you have
received this email in error please delete it and notify the sender
immediately. Before opening any mail and
attachments please check them for viruses and defect.
-----------------------------------------------------------------------------------------------------------------------
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
