Hello All,
I am facing an issue in the video encoder (VPBE) output. I have
programmed the VPBE to output both the analog and digital signal (BT
656). I am getting both the output. Only issue that I am facing is,
there are unwanted lines which are running over the display. It's
appearing both for the analog and digital output. If I set the VIDCTL
VCLK Enable (VCLKE), I am facing this issue. If I did not set this, I am
getting the proper display in the analog output. But, the digital output
will not work, because the VCLK is not enabled.
I am setting the SYS_VPSS_CLKCTL as 0x18, the VENC_DCLKCTL as 0x0800 and
the VENC_DCLKPTN0 as 0x01.
Does anyone face the similar issue? Is this issue could be due to
software register settings/hardware issue?
Thanks a lot in advance.
Regards,
Prabhaharan.R
DISCLAIMER:
-----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and intended
for the named recipient(s) only.
It shall not attach any liability on the originator or HCL or its affiliates.
Any views or opinions presented in
this email are solely those of the author and may not necessarily reflect the
opinions of HCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification,
distribution and / or publication of
this message without the prior written consent of the author of this e-mail is
strictly prohibited. If you have
received this email in error please delete it and notify the sender
immediately. Before opening any mail and
attachments please check them for viruses and defect.
-----------------------------------------------------------------------------------------------------------------------
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
