Hi Chaithrika,
On Wed, Dec 3, 2008 at 5:56 PM, <[EMAIL PROTECTED]> wrote:
> From: Chaithrika U S <[EMAIL PROTECTED]>
>
> Adds ET1011C Phy driver. This driver is used by DM646x.
This driver too should come from mainline, so you need to submit this
driver to LKML and net-dev mailing list.
> +
> +#define ET1011C_STATUS_REG (26)
> +#define ET1011C_CONFIG_REG (22)
If this register off then please convert them to hex values.
> +
> +int et1011c_config_aneg(struct phy_device *phydev)
> +{
This should be static.
--
---Trilok Soni
http://triloksoni.wordpress.com
http://www.linkedin.com/in/triloksoni
_______________________________________________
Davinci-linux-open-source mailing list
[email protected]
http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
