Hi, When I check the UART, it is constantly sending out a BOOTME command. When I tried sending the sfh command out again it went through but then stopped at "Sending the UBL..." Do I have to do something else?
Thanks Neerav -----Original Message----- From: Griffis, Brad [mailto:[EMAIL PROTECTED] Sent: Monday, December 08, 2008 1:28 PM To: Neerav Patel; [email protected] Subject: RE: serial updating question Is your board setup for UART boot such that it's spewing out "BOOTME"? If not, there's no way for the utility to download itself to the device. Brad ________________________________________ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Neerav Patel Sent: Monday, December 08, 2008 2:39 PM To: [email protected] Subject: serial updating question Hi, I recently got some new NAND Flash for the DM355 EVM. I want to download Montavista image that I compiled on the host side using the Getting Started Guide. I was told to use this http://wiki.davincidsp.com/index.php?title=Serial_Boot_and_Flash_Loading_Utility utility, so I compiled this and ran it, and no matter what I do it stops at "Waiting for the DM35x.". The simple command that I typed in the shell was "mono sfh_DM35x.exe -nanderase" I tried to use the command that will allow me to download the image to the flash, but that did the same thing? Any help would be greatly appreciated! Neerav _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
