Hi, So I managed to get it to send data and write to flash, but now the flash isn't really booting into the U-Boot prompt. What address should the UBL and U-Boot be written to, in the flash?
Thanks in advance. Neerav -----Original Message----- From: Neerav Patel Sent: Tuesday, December 09, 2008 9:13 AM To: 'Griffis, Brad'; [email protected] Subject: RE: serial updating question Hi, I am using Linux and everything is installed, including mono. I can run the program and everything, it just stops at "Sending UBL..." Neerav -----Original Message----- From: Griffis, Brad [mailto:[EMAIL PROTECTED] Sent: Tuesday, December 09, 2008 6:55 AM To: Neerav Patel; [email protected] Subject: RE: serial updating question If you're using Windows, do you have .Net Framework 2.0 installed? If you're using Linux did you install mono? Brad > -----Original Message----- > From: Neerav Patel [mailto:[EMAIL PROTECTED] > Sent: Monday, December 08, 2008 4:43 PM > To: Griffis, Brad; [email protected] > Subject: RE: serial updating question > > > Hi, > > When I check the UART, it is constantly sending out a BOOTME command. > When I tried sending the sfh command out again it went through but then > stopped at "Sending the UBL..." Do I have to do something else? > > Thanks > > Neerav > > > -----Original Message----- > From: Griffis, Brad [mailto:[EMAIL PROTECTED] > Sent: Monday, December 08, 2008 1:28 PM > To: Neerav Patel; [email protected] > Subject: RE: serial updating question > > Is your board setup for UART boot such that it's spewing out "BOOTME"? If > not, there's no way for the utility to download itself to the device. > > Brad > > ________________________________________ > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf > Of Neerav Patel > Sent: Monday, December 08, 2008 2:39 PM > To: [email protected] > Subject: serial updating question > > Hi, > > I recently got some new NAND Flash for the DM355 EVM. I want to download > Montavista image that I compiled on the host side using the Getting > Started Guide. I was told to use this > http://wiki.davincidsp.com/index.php?title=Serial_Boot_and_Flash_Loading_U > tility utility, so I compiled this and ran it, and no matter what I do it > stops at "Waiting for the DM35x.". The simple command that I typed in the > shell was "mono sfh_DM35x.exe -nanderase" > > I tried to use the command that will allow me to download the image to the > flash, but that did the same thing? > > Any help would be greatly appreciated! > > Neerav _______________________________________________ Davinci-linux-open-source mailing list [email protected] http://linux.davincidsp.com/mailman/listinfo/davinci-linux-open-source
